Laser Processing Systems
Beyond cutting, marking and welding: rebuild worn parts with laser cladding, machine micro features, print metal parts and mark oversized workpieces — each system configured for your material and part.
Machines in this range
Pick a machine for full details.
1070 nmLaser Cladding Machine
Fuse a wear- or corrosion-resistant metal layer onto shafts, rolls and dies — rebuild worn parts instead of replacing them.
355 / 532 / 1064 nmLaser Micromachining System
Micron-level cutting, drilling, scribing and patterning of thin metals, films, glass and ceramics.
1070 nmMetal 3D Printer (SLM)
Selective laser melting builds dense metal parts layer by layer — complex geometry, no tooling.
1064 nm / 10.6 µmLarge Format Laser Marking Machine
Gantry-mounted laser head marks and engraves oversized sheets, panels and heavy parts in one setup.
Which process?
Match the process to the job.
| What it does | Typical parts | Why laser | |
| Laser cladding | Fuses a new metal layer onto a surface | Shafts, rolls, dies, valve seats, hydraulic rods | Dense bond, low heat — rebuild instead of replace |
| Laser micromachining | Cuts, drills and patterns very small features | Stencils, medical parts, wafers, thin films, glass | Tiny heat-affected zone, burr-free edges |
| Metal 3D printing | Builds metal parts layer by layer from CAD | Mould inserts, implants, lattices, prototypes | Complex shapes with no tooling |
| Large-format marking | Marks and engraves across a large bed | Panels, signage, tiles, dies, heavy parts | One setup for oversized work, seamless fields |
Applications
Where laser processing pays off.
- Rebuilding worn shafts, rolls and moulds instead of buying new
- Hard-facing and corrosion protection for pumps, valves and hydraulics
- Micro-features for electronics, medical devices and EV components
- Prototypes, conformal-cooling inserts and short production runs in metal
- Marking big panels, signage and heavy parts without moving them
FAQ
Common questions
Which process is right for my part?
It depends on what you need to change — add material (cladding), remove very small amounts precisely (micromachining), build the whole part (3D printing) or mark a large surface. Send a drawing or photo and we will recommend the process.
Can you run a trial before I buy?
Yes. Share the part, drawing or CAD file and the material; we will advise on feasibility and arrange a sample where possible.
Are these machines customised?
Yes — power, work area, motion (gantry, robot or stages), fixtures and software are configured for your part and volume.
Do you install and train?
Installation, commissioning and operator training at your site are included, with service and AMC after.
Have a special laser application?
Tell us the part and the result you need — we'll suggest the process and the machine.